联系人:魏经理
电话:15165311861
手机:15165311861 15853170198
地址:济南市标山南路绿地东门
当前位置:首页-新闻中心新闻中心
济南玻璃隔断讲解玻璃门安装要注意哪些问题
作者:admin 来源:本站 发布时间:2014-07-21 11:42:24 浏览次数:1418
弹门的上下门轴要座于门框的中心,使玻璃门安装好以后也能座于门框的中心,起到美观的效果。还有一个细节问题要注意,门轴与门夹的部位要注入黄油,可以减少连接件的磨损,以延长使用寿命。
To play door and door hinges in the center of the door frame, the glass door after installed can seat in the center of the door frame, to have the beautiful effect. With a detail to note that a shaft door and the door of the parts to inject butter, can reduce the fitting of wear, to prolong service life.
上下门轴必须在一个垂线上,玻璃门必须采用钢结构的横梁做骨架,上轴必须焊接在横梁上,因为上门轴是整个玻璃门的支撑点,必须要牢固。禁止采用上部横梁采用细木板木龙骨结构,因为上门轴与木制作结构连接点只能使用自攻螺丝固定连接,由于开门次数多,时间长了使上门轴容易脱落,造成危险。
Gate shaft must be up and down on a vertical line, glass door must adopt steel structure beam frame, the shaft must be welded on the beam, because the door shaft is the strong point of the glass door, must be strong. Prohibited USES the upper crossbeam USES the fine wooden wooden keel structure, because the door shaft with wooden structure self-tapping screws can be used at a join point connection, because the door number is much, time grew to make the door shaft is easy to fall off, dangerous.
预埋地弹簧时要在原地面剔凿一个长方形方坑,四周要大于地弹簧底座的10毫米,用于塞实高标号水泥砂浆,起到牢固的作用。建议地弹簧水泥凝固48小时后安装玻璃门,安装好玻璃门地边要距地8-12毫米,预防玻璃门在下垂的时候摩擦地面。
Stuck between embedded to the original ground floor spring cut a rectangle square hole, round than 10 mm of floor spring base, used to fill high grade cement mortar, play a strong role. Advice to spring cement solidification after 48 hours to install the glass door, installed glass door juggle to from 8 to 12 mm, prevent friction ground glass door in the sag.
济南玻璃隔断http://www.dljianlei.com/